RACEshield Bicycle Protection Kits/Film - This video is to involve you better with the step by step instructions on the pack. - Free the crank arm from dirt & grease (& I really mean clean!) with rubbing alcohol or anything along that line for optimal adhesion. - A very mild solution of soap (1~1.5ml of johnson baby bath to 1L or water) is required. Spray bottle or bowl is up to our preference. This retard adhesion time so you have ample time to adjust! - Always keep your finger wet while handling/installing, to reduce fingerprints or any reduction in adhesion. - Slide, aim & align to position. - Wet the surface of the shield so, it is slippery & smooth to push out (squeegee or credit card) the solution like butter! - Press (in a rolling motion) with fingers or palm on the edges. Stay on for stubborn edges as human heat accelerates adhesion time. - Ready to trash the tarmac or trail after a full 24hrs of curing/drying.
Tags: raceshield, Shimano, SRAM, Campagnolo, crankset, crankarm, Dura-ACE, bicycle, howto, custom, diy, installation, paper skateboard, electronics, software, mod, engine, mobile, bike, mountain, ride, biking, riding, cycling, downhill, trail, trial, dirt, mountain bike, how-to, extreme, race, trials, robot, consoles, instruction
No comments:
Post a Comment